 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
15 hp 3P motor run on 10 HP Desco Panel?
Please forgive my ignorance but in the interest of possibly saving
money, can I use the 15 HP motor I already have with my 10HP Desco panel without too much adverse consequence? The idler is a 208V "soft start" type. I'd be willing to do a pony motor start if that is an issue with such a setup What consequences do you foresee in terms of voltage/amp output and heat if any? I am trying to run a 3 HP Monarch lathe. I may have to run my Brown and Sharp mill also although not necessarily simultaneously. All advise and perspectives greatly appreciated. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Main Panel and Sub Panel questions and the NEC | Home Repair | |||
| Main Panel and Sub Panel questions and the NEC | Home Repair | |||
| 2nd panel running off of primary electrical panel | Home Repair | |||
| gluing panel in flat panel door | Woodworking | |||
Threaded Mode
