Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Using caps to balance 440V RPC
I read a lot of write ups on using capacitors to balance the 3PH out of a
idler motor. But, I can't find anything on using them with a 440V system. Brief description of my set-up: (what I'm trying to run is a 5HP 440V lathe motor 2 speed, reversible) I have a 110V 1PH 1.5HP pony motor, belted to a 230V 3PH 7.5HP idler motor. Feeding the idler motor with 220V 1PH on A & C leg, wild leg on B. A B & C feed into a 440/208 auto transformer 'backwards' to boost the voltage. I'm having a hell-uv-a time dialing in my 440V. I have multi taps on the transformer, but try as I might. I just can't get 3 legs of 440. I can get two, but as soon as I try to dial in the wild leg, (using the taps) one of the other legs goes high or low. Any help appreciated -- Peace Milo http://s235.photobucket.com/albums/ee67/mholroyd/ |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
220-440v transformer | Metalworking | |||
fs: anyone need a couple of 440V VFDs (1 HP) | Metalworking | |||
Balance pot. | Electronics Repair | |||
out of balance | Woodturning | |||
7.5hp 3 phase, 440v to 220v. Am I wiring this up right? | Metalworking |