Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Fence Spear Tips?
|
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Fence Spear Tips?
"RO" wrote in message om... I used one inch galvanized water pipe to make a metal fence. I want to put spear tips on the tops but can't find any manufacturer that makes one that will fit over a 1" pipe. The outside diameter is 1 3/8". Any ideas. I can email pictures of what I need. I need about 200. You could start with a weld on or drive on end cap, http://www.mcnichols.com/products/ha...eldon/endcaps/ Then have whatever shape you wanted cut with laser, plasma or waterjet and welded to the cap. Or make a pattern and have them cast at a local foundry? Are you SURE about that 1 3/8" OD?? 1" black/galvanized pipe specs 1.315". |
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
Fence Spear Tips?
On Fri, 19 Dec 2008 21:23:58 -0800, "RO" wrote:
I used one inch galvanized water pipe to make a metal fence. I want to put spear tips on the tops but can't find any manufacturer that makes one that will fit over a 1" pipe. The outside diameter is 1 3/8". Any ideas. I can email pictures of what I need. I need about 200. Thanks, Bob http://www.kingmetals.com/ |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Any tips for patching a knot hole in a fence? | Woodworking | |||
Gravel in vinyl fence post holes? Any tips? | Home Repair | |||
Welding cast iron spear to steel picket? | Metalworking | |||
Good Old Spear & Jackson | UK diy | |||
fence installation tips needed (3-rail post & rail and wire mesh) | Home Repair |