 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Advice needed on replacing spindle bearings in Enco Mill Drill
I have a well used Enco Mill Drill which is made by Rong Fu in Taiwan. I
think it's the model RF-20. The spindle on it has a bit of play and tends to produce lots of harmonics and chatter when boring or using the side of an endmill to cut. I don't know much about these so this may be something that can be addressed by turning a spanner, or maybe it needs new spindle bearings. If anyone has had to correct this on one I'd really appreciate any input on what the cause usually is and how to go about fixing it. Thanks, Michael. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Advice needed on steam engine repair | Metalworking | |||
| Advice on a drill press, & misc questions | Metalworking | |||
| Need info re spindle taper and stuck chuck on Craftsman 150 drill press | Metalworking | |||
| Jet mill drill pulley/speed chart needed | Metalworking | |||
| Mill drill, or drill mill? | Metalworking | |||
Threaded Mode
