 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Usiing hydraulic motor to power mower
I'm trying to run a mower deck with a hydraulic motor. It spins @ 90 rpm
and I need to provide 2200 rpm. I was planning on #60 chain @ 4:1 from motor to a jackshaft then single belt @ 6:1 to get the speed up. Will this work or do I need to re-think? Thanks in advance! |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 1 to 3 phase converter power factor question | Metalworking | |||
| retrofitting an ATX psupply into a microATX psupply box - won't power | Electronics Repair | |||
| recommend a push or power assist mower? | Home Ownership | |||
| Quality Of Tools | UK diy | |||
| Power surges 1/ 2 | Home Repair | |||
Threaded Mode
