On Sun, 05 Mar 2006 12:19:51 -0600, Jon Elson
wrote:

CRL wrote:
I'm trying to run a mower deck with a hydraulic motor. It spins @ 90 rpm
and I need to provide 2200 rpm. I was planning on #60 chain @ 4:1 from
motor to a jackshaft then single belt @ 6:1 to get the speed up. Will this
work or do I need to re-think? Thanks in advance!


90 RPM? Are you sure about that? Most hydraulic motors turn
QUITE a bit faster than that, usually in the 1000 RPM range.
If it has a gear train on the output, can you remove the gearbox?

Jon
Sounds like a hydraulic steering servo motor. Can't remember the
generic name offhand - something like orbital.
*** Free account sponsored by SecureIX.com ***
*** Encrypt your Internet usage with a free VPN account from http://www.SecureIX.com ***