Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Valve question
A certain valve has a rating of 29"/hg. What is the P.S.I. Equiv. of
this? Was the valve rated for vacuum and not pressure? Just need to know before I buy some of these. If in fact the valve was made for a vacuum system,will it function(on air) with the equiv pressure(That I am hoping one of you folks can tell me). I just need them for 20 lbs of air pressure. Thanx, Mark |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Valve question
wrote in message oups.com... A certain valve has a rating of 29"/hg. What is the P.S.I. Equiv. of this? (clip) I just need them for 20 lbs of air pressure. ^^^^^^^^^^^^^^^^ A rating of 29"Hg is meaningful only in terms of vacuum. The equivalent rating in PSI would be 14.7, but may not be a valid conversion. A valve intended for vacuum service at 29" of mercury is probably designed to have less than a certain specified leakage. This would be of no particular interest if you are going to use the valve under pressure. |
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
Valve question
Leo Lichtman wrote:
wrote in message oups.com... A certain valve has a rating of 29"/hg. What is the P.S.I. Equiv. of this? (clip) I just need them for 20 lbs of air pressure. ^^^^^^^^^^^^^^^^ A rating of 29"Hg is meaningful only in terms of vacuum. The equivalent rating in PSI would be 14.7, but may not be a valid conversion. A valve intended for vacuum service at 29" of mercury is probably designed to have less than a certain specified leakage. This would be of no particular interest if you are going to use the valve under pressure. Not only that, most vacuum valves I've looked at seemed to be distinctly one-way. By that I mean that they expect vacuum on a specific side and atmosphere on the other. A vacuum gate valve might be happy with 20 psig on the atmosphere side and atmosphere on the vacuum side, but not the other way around. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Plastic water valve question ...again | Home Repair | |||
Heating Relief Valve and Motorised Valve - Bit Long | UK diy | |||
Thermocouple / gas valve question ? | UK diy | |||
New flat - radiator valve question | UK diy | |||
moving water main valve | Home Repair |