Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
FS Hydraulic manifolds w/silenoid valve
I have some Hydraulic manifolds w/solenoid valve/valves. Is there any
interest in them? They are made of aluminum and appear to be new except one which looks so good you would think it as new. They are all clean and either have caps in the ports or are wrapped in plastic bags with oil inside the bag. Some names and numbers a HPS 0783A M13485 has 3 Hydraforce solenoid valves # 63510122802on it. 12 VDC HPS 07838B, M14611, ASSY D7839B, 101303 with t cartridges with RV08-22H, 0339 on the cartridge. With 3 HYDRAFORCE 12 VDC 4301612 2503 solenoids on it. May have been used for a test. 02592190 HYDAC USA 02580997 MANSOL M30-1368 with one HYDAC 12VDC solenoid valve and some sort of cartridge valve on/in it. 02592152-B HYDAC USA 02580975-A, NDS 37/02. It has 3 HEYDAY 12 VDC solenoid valves and 2 of some sort of cartridge valves in it. 02592190-A HYDAC USA 02580997-A NDS 37/02 with 1 solenoid valve and 1 sort of cartridge valve. 02592152 HYDAC USA 02580975, ND. has 3 solenoids and 2 of some sort of cartridges I have one block that has Compact Controls 320509 12VDC solenoid valve and a cartridge in it. Has 4 ports with CAPPLUG RP0-110 and 1 small port may be for a gauge with a RP0-104 in it. I have one block that has 4 ports with no name on it, but appears to have a spool inside it. It has 2 solenoids back to back on one end mounted like it would move a spool one direction by energizing one solenoid and the other solenoid would move it back to where it was. The solenoid has the name STERLING HYDRAULICS 24 VDC 14W, CCS 024 S. PAT. 5002253 Any interest in these or I will scrap them out. Richard W. |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
FS Hydraulic manifolds w/silenoid valve
Richard W. asked:
Any interest in these or I will scrap them out. Perhaps you could mention the size of the ports? Perhaps post to alt.crafts.blacksmithing where someone may be building a pneumatic hammer or hydraulic press? dennis in nca |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Heating Relief Valve and Motorised Valve - Bit Long | UK diy | |||
Metal Working Machinery New and Used in Australia and for Export | Metalworking | |||
change washer hookup --- but no shutoff valve in sight! | Home Repair | |||
Motorized valve problem | UK diy | |||
Slightly tricky plumbing question | Home Ownership |