 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Question about a dual wound 3ph motor
A friend has acquired an elderly lathe with a dual-wound 3ph motor. It
has 6 wires going in to it, and is intended for 415v 3ph UK supply, but he only has a normal single phase 240v domestic supply. He has been told that he cannot use a single to 3ph VFD with dual-wound 3ph motors. Is this true? If so, why? -- Regards, Gary Wooding (To reply by email, change feet to foot in my address) |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Grizzly 1023 Motor Question | Woodworking | |||
| Small motor wiring... | Metalworking | |||
| Slow down a drill press: 2nd motor and use the existing motor as a countershaft? | Metalworking | |||
| using a 1140RPM motor with VFD | Metalworking | |||
| 3 phase motor question??? | Woodworking | |||
Threaded Mode
