Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Crimping large cable lugs without a crimper
Ignoramus25589 wrote:
I will soon need to crimp many terminals on many short, but thick, 1 gauge or 0 gauge cables. Crimpers are just too expensive. Is there some way to get acceptable crimps without a crimper. I guess, also, that I could buy one on ebay and later sell it, but I would prefer to avoid that. i Perhaps just purchase a set of replacement dies for the expensive crimpers and operate them in a large vise or hydraulic press. Should give you the legit crimp for a lot less $ and time and effort. Pete C. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
A challenge for old house lovers | UK diy | |||
Correction factors in running cable | UK diy | |||
Car aerial cable | UK diy | |||
Routeing Electrical FTE cable | UK diy | |||
Grounding Rod Info | Home Repair |