 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Pto tiller question
I have an old pto tiller from a Ford LGT tractor, and I want to perhaps
adapt it for use on my Kubota, but not sure what the shaft speed was on the Ford......pretty sure it was much faster than the 550 and 800 rpms that are available on the Kubota... If anyone knows offhand or has one that runs off 550 and or 880 rpms and could perhaps check it and let me know what the usual reduction ratio from the shaft on out to the tines would be for your typical pto drive tiller it would be greatly appreciated. Thanks, -- SVL |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Good morning or good evening depending upon your location. I want to ask you the most important question of your life. Your joy or sorrow for all eternity depends upon your answer. The question is: Are you saved? It is not a question of how good | Woodworking | |||
| To anyone sick of alt.hvac | Home Repair | |||
| OT Guns more Guns | Metalworking | |||
| Plumbing Question | UK diy | |||
| Question????? | Woodworking | |||
Threaded Mode
