 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Phase II Micro tool QC post on Myford ML7?
Doug Warner wrote:
I'm wondering if this tool post set: http://www.littlemachineshop.com/pro...ProductID=1672 will fit my Myford ML-7 lathe? If anyone has one of these, can they answer a few questions please? 1. What is the ID of the mounting hole? 2. What is the distance between the mounting hole's center and the closest edge of the release lever base? (Clearance for nut and washer) Thanks in advance. That Web site says it uses a 10mm mounting bolt. - GWE |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Wiring a 480V Single Phase Circuit | Home Repair | |||
| Lathe tool post question | Metalworking | |||
| For peer review, new FAQ section: Power Tools. | UK diy | |||
| Basics on Depth of Cuts | Metalworking | |||
| Quick change tool post question | Metalworking | |||
Threaded Mode
