Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Torch Cooler Pictures in Dropbox
I just posted pictures of the Torch Cooler that I recently finished in
the dropbox. they are titled Trch_Cooler Bob |
#2
|
|||
|
|||
On Wed, 04 May 2005 02:49:17 GMT, MetalHead
wrote: I just posted pictures of the Torch Cooler that I recently finished in the dropbox. they are titled Trch_Cooler Bob Nice compact unit, and good photos. What pressure do you get from the diaphragm pump? Regards, Pete Keillor |
#3
|
|||
|
|||
Peter T. Keillor III wrote:
On Wed, 04 May 2005 02:49:17 GMT, MetalHead wrote: I just posted pictures of the Torch Cooler that I recently finished in the dropbox. they are titled Trch_Cooler Bob Nice compact unit, and good photos. What pressure do you get from the diaphragm pump? Thanks! The diaphram pump maxes out at about 70 or 80 psi, but that just about stalls the motor. I think 40 - 50 is probably the max continuous operating pressure. I have not run this cooler extensively yet. The diaphram pump and the air over water damper are very experimental to me. Without the damper, the pressure pulses from the pump are way to annoying for use on TIG welding. Good Luck, Bob |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
weld-fab-table pictures in dropbox | Metalworking | |||
Question posting pictures | Woodturning | |||
humidity in the house? | Home Repair | |||
Propane Torch problems - Bernzomatic etc | Metalworking | |||
Tig torch questions | Metalworking |