Home |
Search |
Today's Posts |
|
Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
threaded copper supply fittings
I've recently replaced a shower faucet, the old one was sweated directly to the faucet. The new one, as I was told when I bought it, is standard with threaded supply fittings. I installed it, had to reroute some piping to get around some studs, etc since the new one was just bigger enough to require it. Anyway, I've pressure on the faucet for about two weeks now and have some slow leaks at the threaded supplies. I used pipe dope and I threaded it with what I though was enough pressure but not iron-pipe type pressure. Anyone hazard a guess if this is the pipe dope or I didn't torque them down enough? Should I just use tape? I'm going to disassemble the supplies tomorrow and just want to get it right this time. thanks, js |
#2
|
|||
|
|||
threaded copper supply fittings
I would suspect you over heated the pipe dope when sweating the other
fittings. Robert |
#3
|
|||
|
|||
threaded copper supply fittings
Yep, I agree. He should wrap the pipe with a wet rag between where the
soldering point is and what shouldn't be exposed to excess heat. Bob "Robert Rushing" wrote in message ... I would suspect you over heated the pipe dope when sweating the other fittings. Robert |
#4
|
|||
|
|||
threaded copper supply fittings
"Liquid Smoke" wrote in message news:Y45Dc.105$876.100@fed1read07... I've recently replaced a shower faucet, the old one was sweated directly to the faucet. The new one, as I was told when I bought it, is standard with threaded supply fittings. I installed it, had to reroute some piping to get around some studs, etc since the new one was just bigger enough to require it. Anyway, I've pressure on the faucet for about two weeks now and have some slow leaks at the threaded supplies. I used pipe dope and I threaded it with what I though was enough pressure but not iron-pipe type pressure. Anyone hazard a guess if this is the pipe dope or I didn't torque them down enough? Should I just use tape? I'm going to disassemble the supplies tomorrow and just want to get it right this time. leaks at the threaded connections. do i got this right? the other response is talking about sweated connections so im not sure.. teflon tape should be used to keep threaded connections from leaking. randy |
#5
|
|||
|
|||
threaded copper supply fittings
What pipe dope? You should use teflon tape on threaded fittings.
-- _____________ HomeBrewer Remove the xxx to reply! |
#6
|
|||
|
|||
threaded copper supply fittings
"HomeBrewer" wrote in message ... What pipe dope? You should use teflon tape on threaded fittings. -- _____________ HomeBrewer Remove the xxx to reply! I'm the original poster. Yes, I wanted to try pipe dope to avoid having to mess with the tape. Just redid the threads with tape, and a few sweat joints yesterday. No leaks, sticking w/ the tape for now on. Shoulda known better but it was an easier enough fix, this time. thanks all. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Determining Geologic Sources of Native American Copper | Metalworking | |||
Mix copper and pvc/cpvc supply lines? | Home Repair | |||
Generator Grounding | UK diy |