replying to clare, Sailor Rick wrote:
I have a Kohler 19hp Courage on a toro Z4200 and I am facing a problem with
a crack on the housing and oil is leaking out from the top. My son said that
it was a crankcase vent problem. Would this have something to do with the
breather tube. Please advise me on what I should check. I don't have a gas
issue. Motor starts and runs fine BUT after a while the oil is down to empty.

--
for full context, visit http://www.homeownershub.com/mainten...em-641679-.htm

On Tue, 16 Aug 2016 01:14:01 +0000, Sailor Rick
wrote:

replying to clare, Sailor Rick wrote:
I have a Kohler 19hp Courage on a toro Z4200 and I am facing a problem with
a crack on the housing and oil is leaking out from the top. My son said that
it was a crankcase vent problem. Would this have something to do with the
breather tube. Please advise me on what I should check. I don't have a gas
issue. Motor starts and runs fine BUT after a while the oil is down to empty.


Crack in the housing? Doesn't sound good. Post a picture somewhere.

wrote:
On Tue, 16 Aug 2016 01:14:01 +0000, Sailor Rick
wrote:

replying to clare, Sailor Rick wrote:
I have a Kohler 19hp Courage on a toro Z4200 and I am facing a
problem with a crack on the housing and oil is leaking out from the
top. My son said that it was a crankcase vent problem. Would this
have something to do with the breather tube. Please advise me on
what I should check. I don't have a gas issue. Motor starts and
runs fine BUT after a while the oil is down to empty.


Crack in the housing? Doesn't sound good. Post a picture somewhere.

Sailor Rick needs to check out the Kohler Engine Group over at yahoogroups
.. Lots of knowledge over there .
--
Snag

replying to Chris Lewis, Alexcwt wrote:
I assume you want the undercabinet light to be independent of overhead light.

You can add a small 120v (coil) SPDT relay to create an always hot wire. It
would draw a small amount of power when it's in the close position but save
you the need to run another wire in the wall to the switch.

The con: it's going to make a click sound every time either of the 3 way
switch is flicked.

Please check your local code before doing this.

--
for full context, visit http://www.homeownershub.com/mainten...itch-9697-.htm