A few years back, I picked up a Whirlpool convertible dishwasher at an
estate auction. The dishwasher seemed to be in good condition, and
had many parts with it. The unit had been hooked up as a built-in at
its previous owner's home, so when I took it home and tried to hook it
up to my sink, I ended up with a mess of water everywhere. I didn't
get a chance to sit down and play with it to figure out that I just
needed to reattach a couple of hoses to make it work until recently,

Anyway, I hooked it up to the sink a week ago to test it out now that
I had reattached the hoses and it worked fine. I decided that since
we have a facuet-attached water filter which won't let us connect the
washer and no where near the sink to place the dw, that I would run
plumbing to another location in our kitchen and again make it a built-
in.

I ran the plumbing: a 1-1/2" drain and a .5" pex water line. No
problems. My first problem came about when I hooked it up to the
dishwasher using the original 4' krinkly hose. It was too long just
being coiled up right under the washer, and was not letting all of the
water drain from the tub until hours later (it was SLOOOOW)

So, I made a shorter drain hose that would not cause any drain
problems. But now...I get no water! _

-------------------------------------
-- actual problem / question below --
-------------------------------------

Actually, when I start the washer (holding the door latch down with a
screwdriver, so I can see), I see water running in to fill up the
bottom of the basin, but not reaching the heating element. Then, it
attempts to spray water from the arms, but it just spurts strong once
or thrice, then stops, then spurts again every couple seconds, then
eventually you can just see water slightly tricling out of the arm.
It's not enough to make it spin, nor enough to open the telescoping
center part of the arm.

From my research so far, I have tested the inlet valve with a ohmmeter
(.7 ohms across the terminals, IIRC). And I also pulled one of the
hoses off and just let it pump into a bucket--water came out, but I
don't know if it was at a high enough pressure.

The motor is noisy during all of this, and I'm worried that it is
going out. Is there some way I can test this motor? Also, I heard
that a broken impeller can cause this kind of issue. Any ideas? I
don't mind taking this thing apart...but only if there is really a
chance I can do some good with it.

It was supposed to be a gift for my wife, and now it's just
disappointing.