Per an earlier discussion, I have been trying to ensure that I will
not have a future problem with T&P valves in my house... bought a
pressure gauge at the Despot last night on my way home from work
(there's a rant in there, but not pertinent) hooked it up, system
pressure is about 68-70 PSI falling to 60 PSI with a faucet open and
momentarily spiking to maybe 78 PSI. This is measured in the
basement, at about the level of the T&P valves. I left the gauge
connected overnight and the hot water heater went through at least two
cycles and the telltale did not rise.

Everything I've read says that pressure should be regulated to 60 PSI
or less, I am guessing since I did not experience a rise in pressure
when the water heater cycled that I don't have a BFP on the main water
line (actually, the weird thing is I don't even know if I have a
meter, I can't see one unless it is buried underground) so "by the
book" I should install a pressure reducer set for 60 PSI but since a
pressure reducer would also act as a BFP I would then need to add an
expansion tank as well.

Question is, is this really necessary or is 70 PSI OK? I'm not
looking to spend a lot of money on plumbing but if the high pressure
could potentially cause an issue I guess I should take care of it.

thanks,

nate

PS - the Home Despot rant. Found a Watts brand "test gauge" at the
Despot on my way home from work (pressure gauge with telltale, screwed
into a female garden hose fitting) bought it, took it home, found that
the telltale was bent so that it didn't catch the gauge needle. Went
to a different Despot near my house, they didn't have a gauge to
exchange it. Drove back the other direction to go to the original
store, told the guy I wanted to exchange the gauge, well either he
didn't speak English well enough to understand or just didn't know
that you could do a straight exchange, so he refunded my money and I
had to buy another one, meaning I had to stand in line again for 20
minutes to check out... grr... probably wasted a good two hours on
this whole exercise. And then I had to run out again to get matches
(see my other post from this morning) so I didn't even get home until
close to 9 PM. I'm really starting to get sick of plumbing stuff.