Home |
Search |
Today's Posts |
|
Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to alt.home.repair
|
|||
|
|||
Sanding flush to edge wall...
What's the best way to sand the last few inches of a deck up to the
edge? There is an overhand of about 4" above and 4" forward of the edge of my deck (the planks are 90 degrees, not parallel, to the overhang), the rest of which I have sanded very nicely with a belt sander. I can't fit a regular 1/3 sheet sander in there. Apart from a sanding block and lot of elbow grease, is there a sander that will slip up to the edge and do a good job? I have quite a lot to do! Thanks! DeanB |
#2
Posted to alt.home.repair
|
|||
|
|||
Sanding flush to edge wall...
|
#3
Posted to alt.home.repair
|
|||
|
|||
Sanding flush to edge wall...
"dean" wrote in message oups.com... | What's the best way to sand the last few inches of a deck up to the | edge? There is an overhand of about 4" above and 4" forward of the | edge of my deck (the planks are 90 degrees, not parallel, to the | overhang), the rest of which I have sanded very nicely with a belt | sander. I can't fit a regular 1/3 sheet sander in there. Apart from a | sanding block and lot of elbow grease, is there a sander that will | slip up to the edge and do a good job? I have quite a lot to do! | | Thanks! rent an edger 4" is alot of overhang...........should be no more than 2 ". hand scraping is usually how it's done. | | DeanB | |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
RJ45 Flush mounted wall Jack Wiring Help | Home Ownership | |||
Sanding the edge of 3/4 MDF | Woodturning | |||
Will a flush trim bit plow thru or trim one edge only? | Woodworking | |||
Sanding floorboards - Drum Sander and or Edge Sander | UK diy | |||
Sanding floorboards - Drum Sander and or Edge Sander | UK diy |