I have a 3 year old Sears 1/2 hp chain drive opener. It has worked fine
until last night.

Last night three things happened.
1) We lost power twice for about 30 seconds each time
2) It got down to 5 degrees; about the coldest it has been for a long time.
3) The wall switch on my GDO stopped working; the light on the switch was
out, but the remote switches worked normally.

About an hour latter the light was back on, and the switches worked. This
morning they were out again, but now they are okay again.

I figured it was a loose wire unrelated to 1 or 2 above, but I don't see any
loose wires.

Any ideas?

On Feb 5, 9:38 am, "Toller" wrote:
I have a 3 year old Sears 1/2 hp chain drive opener. It has worked fine
until last night.

Last night three things happened.
1) We lost power twice for about 30 seconds each time
2) It got down to 5 degrees; about the coldest it has been for a long time.
3) The wall switch on my GDO stopped working; the light on the switch was
out, but the remote switches worked normally.

About an hour latter the light was back on, and the switches worked. This
morning they were out again, but now they are okay again.

I figured it was a loose wire unrelated to 1 or 2 above, but I don't see any
loose wires.

Any ideas?

Switch, possibly related to 2)...

Toller wrote:
I have a 3 year old Sears 1/2 hp chain drive opener. It has worked
fine until last night.

Last night three things happened.
1) We lost power twice for about 30 seconds each time
2) It got down to 5 degrees; about the coldest it has been for a long
time. 3) The wall switch on my GDO stopped working; the light on the
switch was out, but the remote switches worked normally.

About an hour latter the light was back on, and the switches worked. This
morning they were out again, but now they are okay again.

I figured it was a loose wire unrelated to 1 or 2 above, but I don't
see any loose wires.

Any ideas?

dpb may be right and replacing or bypassing the switch would not be a
bad idea. I will also suggest that power blips can cause problems with the
logic boards and get things out of sync. Often disconnecting them from
power for some time (try and hour or two) and then plugging them back in can
often clear it up.

--
Joseph Meehan

Dia 's Muire duit

On Feb 5, 10:44 am, "Joseph Meehan"
wrote:
Toller wrote:
I have a 3 year old Sears 1/2 hp chain drive opener. It has worked
fine until last night.

Last night three things happened.
1) We lost power twice for about 30 seconds each time
2) It got down to 5 degrees; about the coldest it has been for a long
time. 3) The wall switch on my GDO stopped working; the light on the
switch was out, but the remote switches worked normally.

About an hour latter the light was back on, and the switches worked. This
morning they were out again, but now they are okay again.

I figured it was a loose wire unrelated to 1 or 2 above, but I don't
see any loose wires.

Any ideas?

dpb may be right and replacing or bypassing the switch would not be a
bad idea. I will also suggest that power blips can cause problems with the
logic boards and get things out of sync. Often disconnecting them from
power for some time (try and hour or two) and then plugging them back in can
often clear it up.

--

Rereading post perhaps you're right, too... I thought he said just
the wall switch didn't work, but maybe he meant the lights weren't
switching while power was on as well...if so, that could be the
"confused logic" symptom and the power-down is a reasonable suggestion.