Jeffy3 wrote:

While replacing the flapper valve in our American Standard toilet
(probably 20 something years old) the overflow tube broke right off at
the bottom. It appears that it was screwed in but that the threaded
end is still stuck in the bottom. Any advise on what to do? It would
seem that if I could just get the threaded piece out I could get a new
overflow tube and screw it in. Thanks in advance.


Get the finest tooth hacksaw blade. Break off
one end, so that you can work the teeth in closer.
Hold the blade vertical inside the brass fitting.
(Use a good glove)
Scrape the threads with the teeth as you revolve
the blade around the fitting opening. With some
effort and patience you should be able to extract
the broken brass threads.

Take the old tube to a big hardware store
(I doubt that BigBox will be much help.)
There are 3 different Refill tube (Overflow) diameters.
Match one up. Saw cut to proper length.
Use sealant (Loctite) on the threads.

Jim