Location is Miami Florida. I am going to repaint my house. Single
story CBS (Concrete Block Stucco) with a concrete tile roof.

I need advise on the material to use.

(1) The concrete tile roof was partially damaged during hurricane
Wilma, the roofing company came out and repaired with some new tiles -
same size same model but different color, since that was all they had
in stock I was not in a position to be picky (roofing contractors are
hard to find and book in our areas). So anyways I have now a roof with
80% old tiles, a little faded gray color and 20% new bright white
tiles. Any advise what I can do paint wise? Can I paint concrete roof
tiles? Someone suggested a Elastomeric paint? If I do paint the roof
should I prime with something first? Any suggestions of brand of
elastomeric paint or prime? I have heard of some paint consists of
mildew resistant chemicals, or with reflective properties to keep house
cooler? I am a bit confused as to the best choices in my situation.

(2) As for the house exterior wall, I think the standard is one coat of
prime and two coats of paint? I will be painting it white. In the
past for interior I have used Benjamin Moore's Fresh Start, is this
good for exterior paint too? If so I think I will use that and
Benjamin Moore exterior paint.

(3) The fascia board also need to be sanded and painted. Some of the
existing paint has cracked. Wood seems to be OK. Now, do I need to
remove the aluminum gutters in order to properly sand and paint the
wood, or can I leave it on and sand and paint around it? I am not sure
which is more time consuming, any idea?

(4) There are some minor cracks near one vertical wall, and some other
cracks at the bottom near the ground. I need to seal those before
painting. What should I use to seal those? Caulk it? Stucco over it
or use some specialty sealer?

Any comments and suggestions appreciated.

MC

If the stucco was painted just repaint , no need to prime it, if its
still stucco not painted, re-stuccoing it is best. You can try painting
the tile but it will eventualy fail. Use Ben Moore primer and paint, its
about as good as you can get.

"MiamiCuse" wrote in message
ups.com...
Location is Miami Florida. I am going to repaint my house. Single
story CBS (Concrete Block Stucco) with a concrete tile roof.

I need advise on the material to use.

(1) The concrete tile roof was partially damaged during hurricane
Wilma, the roofing company came out and repaired with some new tiles -
same size same model but different color, since that was all they had
in stock I was not in a position to be picky (roofing contractors are
hard to find and book in our areas). So anyways I have now a roof with
80% old tiles, a little faded gray color and 20% new bright white
tiles. Any advise what I can do paint wise? Can I paint concrete roof
tiles?

I would look to see if a concrete stain exists for such use.

Bob

MiamiCuse wrote:
Location is Miami Florida. I am going to repaint my house. Single
story CBS (Concrete Block Stucco) with a concrete tile roof.

I need advise on the material to use.

(1) The concrete tile roof was partially damaged during hurricane
Wilma, the roofing company came out and repaired with some new tiles -
same size same model but different color, since that was all they had
in stock I was not in a position to be picky (roofing contractors are
hard to find and book in our areas). So anyways I have now a roof with
80% old tiles, a little faded gray color and 20% new bright white
tiles. Any advise what I can do paint wise? Can I paint concrete roof
tiles? Someone suggested a Elastomeric paint? If I do paint the roof
should I prime with something first? Any suggestions of brand of
elastomeric paint or prime? I have heard of some paint consists of
mildew resistant chemicals, or with reflective properties to keep house
cooler? I am a bit confused as to the best choices in my situation.

(2) As for the house exterior wall, I think the standard is one coat of
prime and two coats of paint? I will be painting it white. In the
past for interior I have used Benjamin Moore's Fresh Start, is this
good for exterior paint too? If so I think I will use that and
Benjamin Moore exterior paint.

(3) The fascia board also need to be sanded and painted. Some of the
existing paint has cracked. Wood seems to be OK. Now, do I need to
remove the aluminum gutters in order to properly sand and paint the
wood, or can I leave it on and sand and paint around it? I am not sure
which is more time consuming, any idea?

(4) There are some minor cracks near one vertical wall, and some other
cracks at the bottom near the ground. I need to seal those before
painting. What should I use to seal those? Caulk it? Stucco over it
or use some specialty sealer?

Any comments and suggestions appreciated.

MC

Clean, scrape, prime fascia. We can't see the gutters, so can tell what
to do. Lift them up to reach behind?

Spray exterior with bleach, pressure wash, let dry. There is brushable
caulk that goes on fine cracks and covers well with paint. Acryllic
primer, one coat. Acryllic paint; two coats recommended but ours is
doing great with one.

Elastomeric sounds like high priced acryllic/latex. Use a good brand of
exterior primer and paint. Semi=gloss.

Exterior, if its painted stucco which it probably is. And if its old
and chalky, pealing,etc. Pressure wash the heck out of it to remove as
much loose paint as possible, go over trouble areas with wire brush.
Otherwise you're new paint will be adhearing too loose old paint and
will come off. I would suggest calling in someone with a truck mounted
pressure washer and pump...will do a million times better and faster
than those small units.

For cracks you can fill with outdoor caulking, or use stucco patch. I
find the premixed stucco patch looks like crap and is very noticable,
so i just use a bag of stucco or stucco patch you have to mix yourself.
But you need to fill the cracks, storms push water in and can loosen
the stucco from the block. Also if the cracks are in the block which is
pretty common in florida ,as opposed to just the stucco shrinkage type
cracks, and you really dont want the cracks to come back, grind back
some of the stucco, concrete nail wire mesh over the block cracks, then
put stucco back on and match the texture.

For painting prime if your old paint was very chalky, you'll likely use
two coats of primer cause the stucco will soak it up. Then one coat of
praint will probably do it. You'll use a ton less paint if you prime
the heck out of it.

- shawn

"shawn" wrote in message
oups.com...
Exterior, if its painted stucco which it probably is. And if its old
and chalky, pealing,etc. Pressure wash the heck out of it to remove as
much loose paint as possible, go over trouble areas with wire brush.
Otherwise you're new paint will be adhearing too loose old paint and
will come off. I would suggest calling in someone with a truck mounted
pressure washer and pump...will do a million times better and faster
than those small units.

For cracks you can fill with outdoor caulking, or use stucco patch. I
find the premixed stucco patch looks like crap and is very noticable,
so i just use a bag of stucco or stucco patch you have to mix yourself.
But you need to fill the cracks, storms push water in and can loosen
the stucco from the block. Also if the cracks are in the block which is
pretty common in florida ,as opposed to just the stucco shrinkage type
cracks, and you really dont want the cracks to come back, grind back
some of the stucco, concrete nail wire mesh over the block cracks, then
put stucco back on and match the texture.

For painting prime if your old paint was very chalky, you'll likely use
two coats of primer cause the stucco will soak it up. Then one coat of
praint will probably do it. You'll use a ton less paint if you prime
the heck out of it.

- shawn


Thanks shawn. Very sound advise. Very much appreciated.

MC