Hi, I have a contractor grade GE Profile dishwasher that is cleaning
dishes as well as it ever has, but the water never really drains all
the way. It always leaves about 1 1/2 to 2" of water in the bottom.
Not a spill/leak hazard, it just doesn't seem right.
If I start a cycle and immediately press the cancel button, it will
drain a little more out. Do that a few times and it will eventually
get down to about 1/4 inch of water.
Any thoughts? Anything to try to adjust?
Thanks

Check the drain hose for blockage or kinking.

Don't know about GE but have seen some that there was a filter in the
bottom that would get partial clogged and water would stand in bottom.
So look for such as that could be yoir problem
Jack

you are mixing dirty water into your clean water wash water. wash
dishes by hand until you fix this with help for you now at:

http://applianceguru.com/

http://www.repairclinic.com/0047_9.asp

check the manual

some models keep a small amount of water in the bottom to cover the
turbidity sensor.

autonut843 wrote:
Hi, I have a contractor grade GE Profile dishwasher that is cleaning
dishes as well as it ever has, but the water never really drains all
the way. It always leaves about 1 1/2 to 2" of water in the bottom.
Not a spill/leak hazard, it just doesn't seem right.
If I start a cycle and immediately press the cancel button, it will
drain a little more out. Do that a few times and it will eventually
get down to about 1/4 inch of water.
Any thoughts? Anything to try to adjust?
Thanks

Hi,

No model# posted

-Some- possible trouble makers....
http://www.applianceaid.com/gedishdrain.html
http://www.applianceaid.com/drain_wash.html

jeff.
Appliance Repair Aid
http://www.applianceaid.com/

Thanks! Here is the model number.
MOD GSD4030Z07WW

autonut843 wrote:
Thanks! Here is the model number.
MOD GSD4030Z07WW

Pay extra attention to these items as they can distort and cause
incomplete drain outs....

http://www.repairclinic.com/referral.asp?R=153&N=821081
Piston assembly for check valve
http://www.repairclinic.com/referral.asp?R=153&N=824346
Check valve assembly
http://www.repairclinic.com/referral.asp?R=153&N=270293
Back flush flapper valve ( this is inside the check valve assembly )

http://tinyurl.com/8rzwx
Part breakdown.

jeff.
Appliance Repair Aid
http://www.applianceaid.com/

I had the same problem and replaced the piston assembly for check
valce. The rubber washer was worn. Works perfectly now