 |
|
| Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Looking For-Phono Motor
Looking for a Thorens TD 318 MK III replacement motor source. Any help most
appreciated. Thanks JMC |
|
#2
|
|||
|
|||
|
Can't help with a source, but just to say that you should be sure the motor is bad, and not
simply a case of the wrong belt. I've found that with Thorens tables newer than TD-150, the motors simply won't run right, even not at all, without precisely the right belt. Just a tiny bit too tight or belt too thick & it won't run right or won't start up at all. -- Stephen Sank, Owner & Ribbon Mic Restorer Talking Dog Transducer Company http://stephensank.com 5517 Carmelita Drive N.E. Albuquerque, New Mexico [87111] 505-332-0336 Auth. Nakamichi & McIntosh servicer Payments preferred through Paypal.com "JMC" wrote in message ... Looking for a Thorens TD 318 MK III replacement motor source. Any help most appreciated. Thanks JMC |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Where to find GE motor wiring diagram | Home Repair | |||
| Slow down a drill press: 2nd motor and use the existing motor as a countershaft? | Metalworking | |||
| Knee mill motor problem... sigh. | Metalworking | |||
| using a 1140RPM motor with VFD | Metalworking | |||
| Well, well, well; Delta MAY have listened - the brand new 14 Band Saw now has a RESILIENT MOUNT motor! shades of yesteryear! | Woodworking | |||
Linear Mode
