If no parts are bad, then this means that the monitor is working!

You should determine the area that is not functioning to start with. Once
you know, you can then proceed to properly troubleshoot that area. You will
also have to find the cause of the original failure as well. Most of the
time, the power supply, scan output sections, and the HV sections fail.
Usually the original failures are in the scan amplifier sections in these
monitors, and thus the power supply is also damaged.

Sometimes the original cause of failures are capacitors going high in ESR.
These are not visible failures, therefore, you can stare at these caps for
the rest of your life, and they will never show any visual marks or
indications of failure. You will have to use an ESR meter, or change them to
verify them.

--

Jerry G.
======

"Rono" wrote in message
...
Sun / Sony Monitor Model: GDM20SE20 (N2H Chassis)! Dead, no parts measure
bad! Been a while
since i looked at it! It's in storage! Ideas? Rono.