Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Soft on power problem Magnavox 27" Model HD2763 C401
Resoldering AC input circuits and IR, control button, and microprocessor
sections allow the set to power on normally for a few days. Problem seams to be in the standby power supply going down after a while. Any experience, suggestions? TIA |
#2
|
|||
|
|||
A common problem with many Magnavox TV's is the 100UF 200V electrolytic
capacitor in the power supply goes bad. It is located near the heatsink that holds the 5-pin STR voltage regulator IC. Very common failure. Hope this helps... John |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Packard Bell A720 stuck on "Soft power down" mode ? | Electronics Repair | |||
Quality Of Tools | UK diy | |||
Generator FAQ | Metalworking | |||
Whirlpool oven problem after power outage | Home Repair | |||
Toshiba Rear Projection TV convergence and power problem | Electronics Repair |