Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Static convergence on Thomson 52RG75J?
Hello group,
Anyone know how to adjust the static convergence on a Thomson 52RG75J (ICC9 chassis)? Dynamic convergence is done with pots under the front facade, but I think static convergence is normally done using a service mode in the remote control. Is this correct? I don't have an original remote control, so can't enter the service menu (on orig. menu and + buttons simultaneously). Is there any key sequence that can be used on a universal remote control to enter the service mode? thanks Dan |
#2
|
|||
|
|||
Static is normally relating to mechanical adjustments such as centering,
width, height, etc. Dynamic on all relatively new chasis is always done via a technician setup menu. "Dan Payne" wrote in message . .. Hello group, Anyone know how to adjust the static convergence on a Thomson 52RG75J (ICC9 chassis)? Dynamic convergence is done with pots under the front facade, but I think static convergence is normally done using a service mode in the remote control. Is this correct? I don't have an original remote control, so can't enter the service menu (on orig. menu and + buttons simultaneously). Is there any key sequence that can be used on a universal remote control to enter the service mode? thanks Dan |
#3
|
|||
|
|||
Thanks, but the generalities I know already. I'm looking for the specifics
on this one. It's an old design rear screen projector, with potentiometers for the dynamic convergence, and I can see on the schematic that the static convergence levels (centering etc) are set by a DAC chip on the I2C bus. Therfore I assume that setting is done by the remote control. Dan "Art" wrote in message ... Static is normally relating to mechanical adjustments such as centering, width, height, etc. Dynamic on all relatively new chasis is always done via a technician setup menu. "Dan Payne" wrote in message . .. Hello group, Anyone know how to adjust the static convergence on a Thomson 52RG75J (ICC9 chassis)? Dynamic convergence is done with pots under the front facade, but I think static convergence is normally done using a service mode in the remote control. Is this correct? I don't have an original remote control, so can't enter the service menu (on orig. menu and + buttons simultaneously). Is there any key sequence that can be used on a universal remote control to enter the service mode? thanks Dan |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Convergence on PTV-375 | Electronics Repair | |||
Mits VS60601 convergence | Electronics Repair | |||
PTK195 convergence woes, intermittent of course | Electronics Repair |