Home |
Search |
Today's Posts |
![]() |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]()
my Samsung Front load washing and drying machine 17Kg/9Kg model WD1172XVM is showing the error code dE1 after start has been pressed. I checked up the code on the net and it says its the door. so l changed the door switch but the problem is still there. what may be the cause?
Thanks |
#2
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]() |
#3
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]()
On Friday, May 8, 2020 at 6:05:59 PM UTC-4, wrote:
my Samsung Front load washing and drying machine 17Kg/9Kg model WD1172XVM is showing the error code dE1 after start has been pressed. I checked up the code on the net and it says its the door. so l changed the door switch but the problem is still there. what may be the cause? Thanks If you dead-short the switch, does the code clear? If not, it is not the switch. The switch feeds a relay - check that. Otherwise, unplug it for 10 minutes, and try again. Peter Wieck Melrose Park, PA |
#4
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]()
On Friday, May 8, 2020 at 11:18:35 PM UTC+1, wrote:
On Friday, May 8, 2020 at 6:05:59 PM UTC-4, wrote: my Samsung Front load washing and drying machine 17Kg/9Kg model WD1172XVM is showing the error code dE1 after start has been pressed. I checked up the code on the net and it says its the door. so l changed the door switch but the problem is still there. what may be the cause? Thanks If you dead-short the switch, does the code clear? If not, it is not the switch. The switch feeds a relay - check that. Otherwise, unplug it for 10 minutes, and try again. Peter Wieck Melrose Park, PA Thanks to all of you. I by passed the switches as suggested, but the code only cleared when i pushed the alternative release bar further. This is an indication that the solenoid inside the door switch mechanism is not working.. Further diagnostics shows that the coil is ok but its not receiving power.. Another problem detected was the valve for the inlet water does not energize ( receives no power)to let water in even though i set the solenoid to its working position (the error displayed now is 4E)I wish i can get schematic to trace the power to both the water inlet valve and the door solenoid. Thank you all once again. |
#5
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]() |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Samsung Big Wash washing machine error code Ec | UK diy | |||
Indesit Washing Machine - Error Code ? | UK diy | |||
Bosch washing machine error code | UK diy | |||
Washing machine - pump works ok - but displays error code E1. | UK diy | |||
Error code F08 on Indesit Evolution WE10UK washing machine | Electronics Repair |