Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Tek 7613
After sitting unused for quite a while, the traces of my Tek 7613 scope are
skewed. AFAICS this is not a front panel adjustment, unless I'm blind. And, sorry, no manual :-( Anybody know where to find the "trace-rotation/trace-alignment" pot? Thanks, Jan. |
#2
|
|||
|
|||
Tek 7613
JKoning wrote:
After sitting unused for quite a while, the traces of my Tek 7613 scope are skewed. AFAICS this is not a front panel adjustment, unless I'm blind. And, sorry, no manual :-( Anybody know where to find the "trace-rotation/trace-alignment" pot? Thanks, Jan. It's been a long time since I worked on Tek scopes - if it's not on the front panel, then it might have been located on the storage board; that would be the large circuit board on the right side of the scope, next to the CRT. Pop the covers and snoop around; as I recall, it was a two wire connector (black and red wires) that went to the trace rotation coil. Hope this helps, Bob. |
#3
|
|||
|
|||
Tek 7613
"JKoning" wrote in
.nl: After sitting unused for quite a while, the traces of my Tek 7613 scope are skewed. AFAICS this is not a front panel adjustment, unless I'm blind. And, sorry, no manual :-( Anybody know where to find the "trace-rotation/trace-alignment" pot? Thanks, Jan. On the right rear side of the scope,on the top,is a narrow PCB,that is the Z-axis amp and related CRT (geom,astig,T-rot)adjustments.IIRC,the pot you want is labelled. -- Jim Yanik jyanik-at-kua.net |
#4
|
|||
|
|||
Tek 7613
On Fri, 16 Apr 2004 11:57:45 +0200, "JKoning"
wrote: After sitting unused for quite a while, the traces of my Tek 7613 scope are skewed. AFAICS this is not a front panel adjustment, unless I'm blind. And, sorry, no manual :-( Anybody know where to find the "trace-rotation/trace-alignment" pot? Thanks, Jan. My 7623 has the rotation adjustment located on top of the scope. It was the only top access hole on the scope. These is definitely a rotation adjustment somewhere. Andy Cuffe |
#5
|
|||
|
|||
Tek 7613
I have found the trace rotation pot on the Z-axis board.
Possibly the 7613 found it's successor in the 7623 because of the difficult access of the relevant pot. There's no cover hole to access T-rot. But, it is labeled indeed... , P1170... like all the pot's on the Z-axis board are numbered. Anyway, traces are fine now, flat like the Dutch horizon :-) Thanks everybody for helping out! Rgds, Jan. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|