JKoning wrote:
After sitting unused for quite a while, the traces of my Tek 7613
scope are skewed.
AFAICS this is not a front panel adjustment, unless I'm blind. And,
sorry, no manual :-(
Anybody know where to find the "trace-rotation/trace-alignment" pot?

Thanks,
Jan.

It's been a long time since I worked on Tek scopes - if it's not on the
front panel, then it might have been located on the storage board; that
would be the large circuit board on the right side of the scope, next to the
CRT. Pop the covers and snoop around; as I recall, it was a two wire
connector (black and red wires) that went to the trace rotation coil.

Hope this helps,
Bob.