Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Asimov
 
Posts: n/a
Default Basic Question

Hi,

Have small question about basic electric theory concerning induction.
For example I know that a wire moving through a magnetic field will
induce an emf. However will an electric field also induce an emf if a
wire moves through it? Would this effect be what makes fluorescent
lamps glow underneath power distribution lines?

Asimov
******

.... Just a little force field zap.

  #2   Report Post  
Nigel
 
Posts: n/a
Default Basic Question

"Asimov" wrote in
:

Hi,

Have small question about basic electric theory concerning induction.
For example I know that a wire moving through a magnetic field will
induce an emf. However will an electric field also induce an emf if a
wire moves through it? Would this effect be what makes fluorescent
lamps glow underneath power distribution lines?

Asimov
******

... Just a little force field zap.



A fluorescent tube works by an electric field inside the tube causing a
discharge, and this electric field can come either, as normally, from
applying a mains voltage across the tube, or from the electric field
produced by a power line. So fluorescent tubes will produce a visible glow
under a power line, though usually it is only visible after dark as it is
much weaker than the light they normally produce. The current through a
fluorescent tube under a power line would probably be 20 – 200 microamps
(µA) depending on the field. This is much less than a person can normally
perceive, so you can hold the tube yourself under the power line without it
hurting. (For comparison, a 10 W tube at 230 V draws 40 mA – 200 times
greater). You can sometimes also make a fluorescent tube produce visible
flickers by holding one end and rubbing your foot on a carpet to generate
static electricity, though again, this needs to be done in a dark room.

http://www.emfs.info/sci_EffectsOnEquip.asp


Electromagnetic Induction info

http://makeashorterlink.com/?A24A431E7

A Google search or a decent textbook should also help.
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
this ought to get everybody fired up.... mel Woodworking 56 March 29th 04 03:53 PM
Basic Anodizing Question Statics Metalworking 8 September 6th 03 05:54 AM
Pipe thread question, NPT vs NPSF, MIP, FIP and IPS Jeff Wisnia Metalworking 1 August 9th 03 04:20 AM


All times are GMT +1. The time now is 09:48 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"