I am not sure if anyone has read up on my previous messages or not, but I
believe I have since fixed my monitor problem.

I pretty much just re-flowed all the solder around the flyback and anything
else that I came across and now it seems to be working fine except it's a
little fuzzy.

There is a little hole in the back of the monitor that I questions whether
or not it's the access hole for the focus. I would like to not have to take
the monitor apart again if I could avoid it and if this is the access hole,
it would make my life so much easier.

Does anyone haev any input?

Thanks

Open the monitor and look for the focus pot. In most monitors it is on the
flyback assy., and is built in to part of the HV multiplier.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
=========================================


"Peter" wrote in message
news:094Hb.671300$Fm2.582333@attbi_s04...
I am not sure if anyone has read up on my previous messages or not, but I
believe I have since fixed my monitor problem.

I pretty much just re-flowed all the solder around the flyback and anything
else that I came across and now it seems to be working fine except it's a
little fuzzy.

There is a little hole in the back of the monitor that I questions whether
or not it's the access hole for the focus. I would like to not have to take
the monitor apart again if I could avoid it and if this is the access hole,
it would make my life so much easier.

Does anyone haev any input?

Thanks