Epson Photo 750 Stylus printer, very low usage, carriage stops in odd
places, drive belt sometimes jumps drive gear teeth. Paper not always
fully ejected. It's as if the carriage drive gears are not "timed" up
correctly via the drive belt (I am a race car engineer, excuse the
comparison...). Any info out there to remedy this? Printers are now
pretty cheap, sending it back to Epson may not be cost effective.
Thanks.


--
Best regards,
Chris.

Contact Epson's Support and see the FAQ...the response to your question may be
there!. I had a similar problem with a 700 and by following the troubleshooting
info. I was able to get it fixed.
Alphie

I know it sounds ridiculous but try cleaning the metal bar that the
carriage runs backwards and forwards on, then lightly lubricate with a
lightweight oil. See if that helps.

Dave


Chris Wilson wrote in message m...
Epson Photo 750 Stylus printer, very low usage, carriage stops in odd
places, drive belt sometimes jumps drive gear teeth. Paper not always
fully ejected. It's as if the carriage drive gears are not "timed" up
correctly via the drive belt (I am a race car engineer, excuse the
comparison...). Any info out there to remedy this? Printers are now
pretty cheap, sending it back to Epson may not be cost effective.
Thanks.