Has anyone seen problems using common hardware store gloss enamel to
touch up a microwave oven interior?

Someone emailed me all in a huff that they followed this advise and it now
smells "funky" and smokes. They said the paint color was white and they
waited 24 hours before use. This was apparently under the turntable.

The smell could make sense if there was some residual solvent present and
should go away after awhile, but the "smokes" part is strange unless they
didn't bother to clean and sand beforehand and there was trapped debris.

Any comments appreciated.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.