Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
SONY's VCR RF Input don't work
I have a SONY VHS VCR in which the RF Input seem to be dead.
The RCA input/output and RF output works. The Cable/Antenna signal goes thru the VCR to the TV with no problem. The VCR's Menu/On screen graphics appear on the TV. I have tried to program the channels into the VCR both via auto scan and manually, but, after it finish no channels are programmed. And any channel I try to access by directly entering the channel is also blank This seemed to have happen after the local cable company sent a command to "shut down" their older cable boxes to make way for newer models. However, I can't prove it to the point of getting them to pay for any repairs. So, in the end,why won't the VCR accept any signal via the RF Input? Any ideas? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Plagiarism | Woodturning | |||
How to find a good contractor? | Home Repair | |||
Electrical work - would inspector check previously done work? | Home Repair | |||
Composite video output to "AV in" input? | Electronics Repair | |||
Moisture Cure Urethane (Moisture Cured Urethane) | Woodworking |