Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
Reply Sony STR-V444ES
Sony STR-V444ES speakers audio isnt kicking in.
Good audio to the Headphones is fine. Scoped audio up to relays is fine. but still 27 Volts across relay coil. No signal to drop one side low and thus kick in the relay. WHY ??? ayone run into this before? Yes i have looked for DC, and there isnt any. Also there are 4 different relays, Front-Rear L&R None of them are kicking in. |
#2
Posted to sci.electronics.repair
|
|||
|
|||
Reply Sony STR-V444ES
wrote in message ... Sony STR-V444ES speakers audio isnt kicking in. Good audio to the Headphones is fine. Scoped audio up to relays is fine. but still 27 Volts across relay coil. No signal to drop one side low and thus kick in the relay. WHY ??? ayone run into this before? Yes i have looked for DC, and there isnt any. Also there are 4 different relays, Front-Rear L&R None of them are kicking in. The fact that none of the relays is dropping in, is neither here nor there - except to indicate that the problem is likely *not* related to any particular relay driver. To avoid unncessary duplication, the fault monitoring and switch on delay circuitry, will be a single entity, monitoring all channels simultaneously, and acting on all relay drivers simultaneously. Thus, any fault ( DC offset, over current, over temp etc ) detected on *any* channel, will cause *all* relay drivers to be inhibited. So, I would suggest that your problem lies either with the fault monitoring circuitry itself, or the fact that it is genuinely detecting a problem on one or more channels. Arfa |
#3
Posted to sci.electronics.repair
|
|||
|
|||
Reply Sony STR-V444ES
Arfa Daily wrote:
wrote in message ... Sony STR-V444ES speakers audio isnt kicking in. Good audio to the Headphones is fine. Scoped audio up to relays is fine. but still 27 Volts across relay coil. No signal to drop one side low and thus kick in the relay. WHY ??? ayone run into this before? Yes i have looked for DC, and there isnt any. Also there are 4 different relays, Front-Rear L&R None of them are kicking in. The fact that none of the relays is dropping in, is neither here nor there - except to indicate that the problem is likely *not* related to any particular relay driver. To avoid unncessary duplication, the fault monitoring and switch on delay circuitry, will be a single entity, monitoring all channels simultaneously, and acting on all relay drivers simultaneously. Thus, any fault ( DC offset, over current, over temp etc ) detected on *any* channel, will cause *all* relay drivers to be inhibited. So, I would suggest that your problem lies either with the fault monitoring circuitry itself, or the fact that it is genuinely detecting a problem on one or more channels. Arfa I think I've seen a couple bad 1 ohm resistors in the power supply cause this. They're at the rear corner of the machine. Mark Z. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Possible problems with Sony VCR (model slvn750) | Electronics Repair | |||
Sony KV-20FV300 | Electronics Repair | |||
I dropped the tv ( Sony circa December 1985) | Electronics Repair | |||
SONY 32" KV-32XBR37: Schematics, REAR COVER and "W" CIRCUIT CARD need | Electronics Repair | |||
AG 7350 and Sony Editor ? Qustion for Sony god's or Panasonic god's. | Electronics Repair |