Turned on my TV the other day and was missing video. Can still change
channels, hear audio, see the raster lines (I think), and go through
the menus. But I can't get video from the coax, s-vid, or rca inputs.

I saw where a couple of other people had the same problem a while back
and it was mentioned to "clean the glue off L14401 and resolder it."
But it didn't look like that solved their problem.

Any ideas?

Thanks,
Logan

Check for a bad connection on Connector P103 pin # 4, also check R14119
(15 K 2 watts).

GNK

AgapeDisciple wrote:
Turned on my TV the other day and was missing video. Can still change
channels, hear audio, see the raster lines (I think), and go through
the menus. But I can't get video from the coax, s-vid, or rca inputs.

I saw where a couple of other people had the same problem a while back
and it was mentioned to "clean the glue off L14401 and resolder it."
But it didn't look like that solved their problem.

Any ideas?

Thanks,
Logan

Thanks GNK! I'll check it out tonite.

BTW, did you have this same problem?

Logan

gnk wrote:
Check for a bad connection on Connector P103 pin # 4, also check R14119
(15 K 2 watts).

GNK

AgapeDisciple wrote:
Turned on my TV the other day and was missing video. Can still change
channels, hear audio, see the raster lines (I think), and go through
the menus. But I can't get video from the coax, s-vid, or rca inputs.

I saw where a couple of other people had the same problem a while back
and it was mentioned to "clean the glue off L14401 and resolder it."
But it didn't look like that solved their problem.

Any ideas?

Thanks,
Logan

I resoldered P103 Pin #4 and checked R14119 = 13K ohms. (Is that too
low?) I also checked the error codes. Here's what came up:

1 - 3 | 03 | 12.0V run fault | 12.0V source is failing.
2 - 3 | 03 | 12.0V run fault | 12.0V source is failing.
3 - 44 | 2C | F2 PIP module error | F2PIP fails to acknowledge.

And I resoldered L14401.

Any more ideas?

Logan