Electronic Schematics (alt.binaries.schematics.electronic) A place to show and share your electronics schematic drawings.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to alt.binaries.schematics.electronic
external usenet poster
 
Posts: 1
Default 600 points audio analyseur

Hello,

I'm a French guy so my english is limited...

I've designed and built an audio analyser.

see

http://cjoint.com/?jnuQ3MN7sa

http://cjoint.com/?jnu06pOjqA

It traces gain and phase of HP impedance and frequency response from 20Hz to
20 kHz using 600 steps (not limited to that).

(OK, don't tell me that your sound card does it as well, I know)

My question is: "on witch site could I publish this (open) projet".

For those who knows Elektor, it uses an R8C13.

Best regards

Vincent


  #2   Report Post  
Posted to alt.binaries.schematics.electronic
external usenet poster
 
Posts: 426
Default 600 points audio analyseur

On Thu, 13 Sep 2007 22:04:32 +0200, vincent.thiernesse wrote:

Hello,


Hello. :-)

I'm a French guy so my english is limited...


So far, so good... :-)

I've designed and built an audio analyser.


http://cjoint.com/?jnuQ3MN7sa
http://cjoint.com/?jnu06pOjqA


My question is: "on witch site could I publish this (open) projet".


Isn't that what you've just done, at cjoint.com? Can't you write
it up and post your text to the same site?

Otherwise, your ISP should offer a certain amount of "personal
web space"; at least that's routine as far as I know in the US.
You'd have to go to your ISP's own web site to find out more
about this.

Good Luck!
Rich

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
OT - Points to Ponder Gus Metalworking 0 March 14th 06 07:02 AM
OT - Points to Ponder Ken Metalworking 1 March 13th 06 09:29 PM
TV points in two rooms Paul the D UK diy 3 October 30th 03 09:55 PM
Help, please? Need blunt "points" on dowels Larry Jaques Woodworking 13 September 29th 03 06:33 AM


All times are GMT +1. The time now is 05:45 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"