Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
jwiiiiiiiiiiiiii
 
Posts: n/a
Default wood finish stained white by water

We have a old wooden dressing table. I over-filled a plant pot standing on
it, and some of the water ran out of the saucer and lay for a few day under
a hand mirror.

Where the water lay, it has turned the wood finish a milky white.

Would be very grateful for any advice to remove this white stain please.
Many thanks.


  #2   Report Post  
Ray V
 
Posts: n/a
Default

"jwiiiiiiiiiiiiii" wrote in message
...
We have a old wooden dressing table. I over-filled a plant pot standing on
it, and some of the water ran out of the saucer and lay for a few day
under a hand mirror.

Where the water lay, it has turned the wood finish a milky white.


Misty says to use mayonaise
http://www.wtol.com/global/story.asp?s=1632149

The finish should return on its own if you leave it uncovered so the
moisture can escape. I would give it at least two weeks before tryimg
anything that could make it worse.
--

Too much is not enough!
rvojtash NOT THIS at comcast (dot) net


  #3   Report Post  
George
 
Posts: n/a
Default


"Ray V" wrote in message
...
"jwiiiiiiiiiiiiii" wrote in message
...
We have a old wooden dressing table. I over-filled a plant pot standing

on
it, and some of the water ran out of the saucer and lay for a few day
under a hand mirror.

Where the water lay, it has turned the wood finish a milky white.


Misty says to use mayonaise
http://www.wtol.com/global/story.asp?s=1632149

The finish should return on its own if you leave it uncovered so the
moisture can escape. I would give it at least two weeks before tryimg
anything that could make it worse.
--


Might return pretty much in color, but you've run water through the finish
into the wood, and it'll stand up a bit under the finish unless you are
lucky and had a real good water set before final finish. Warning - if you
use an abrasive on it, it might flake off and look ugly. Oil rub to darken
it - mayo is oil and egg - and live with the swollen fibers.


  #4   Report Post  
Phisherman
 
Posts: n/a
Default

On Thu, 17 Feb 2005 09:07:54 GMT, "jwiiiiiiiiiiiiii"
wrote:

We have a old wooden dressing table. I over-filled a plant pot standing on
it, and some of the water ran out of the saucer and lay for a few day under
a hand mirror.

Where the water lay, it has turned the wood finish a milky white.

Would be very grateful for any advice to remove this white stain please.
Many thanks.


Water has seeped under the finish. A dab of mayonnaise and soft cloth
should help.
  #5   Report Post  
jw 11111
 
Posts: n/a
Default


"Phisherman" wrote in message
...
On Thu, 17 Feb 2005 09:07:54 GMT, "jwiiiiiiiiiiiiii"
wrote:

We have a old wooden dressing table. I over-filled a plant pot standing on
it, and some of the water ran out of the saucer and lay for a few day
under
a hand mirror.

Where the water lay, it has turned the wood finish a milky white.

Would be very grateful for any advice to remove this white stain please.
Many thanks.


Water has seeped under the finish. A dab of mayonnaise and soft cloth
should help.


thanks for the suggestions. left it for two weeks as advised, but very
little change. then applied mayonnaise (hellermans) leaving it on thickly
for a day. but sad to say no real change. any other thoughts gratefully
received. thanks




  #6   Report Post  
Guess who
 
Posts: n/a
Default

On Tue, 01 Mar 2005 19:52:32 GMT, "jw 11111"
wrote:

Water has seeped under the finish. A dab of mayonnaise and soft cloth
should help.


thanks for the suggestions. left it for two weeks as advised, but very
little change. then applied mayonnaise (hellermans) leaving it on thickly
for a day. but sad to say no real change. any other thoughts gratefully
received.


It's more likely "on" than "under" which would darken the wood. From
the sounds of it, ["it's been there a few days"], it might be deep
enough to cause a major refinishing.

If close to the surface [it's in the finish, top layer] a VERY mild
abrasion might do the trick. E.G. salt in veggie oil, rub *lightly*
with a pad or finger in a cloth. E.G a mild abrasive like toothpaste
....rub on wipe off. Some recommend 0000 steel wool ..again applied
very lightly, then rewaxing. I'd use water paper rather than steel
wool if going that way.

  #7   Report Post  
GerryG
 
Posts: n/a
Default

First, take a good look with a raking light. If the surface of the finish
looks porous, you would need to refinish that area. If not, see if you can
identify the finish. If it's very old, might even be shellac. Try warming the
area with a hair dryer (note: warm, not-not hot), and try a cloth ball with
just a little denatured alcohol, rubbing around the area and a firm pressure.
Even if it's not shellac, the alcohol may help. Just keep the pad clean.
GerryG

On Tue, 01 Mar 2005 19:52:32 GMT, "jw 11111"
wrote:


"Phisherman" wrote in message
.. .
On Thu, 17 Feb 2005 09:07:54 GMT, "jwiiiiiiiiiiiiii"
wrote:

We have a old wooden dressing table. I over-filled a plant pot standing on
it, and some of the water ran out of the saucer and lay for a few day
under
a hand mirror.

Where the water lay, it has turned the wood finish a milky white.

Would be very grateful for any advice to remove this white stain please.
Many thanks.


Water has seeped under the finish. A dab of mayonnaise and soft cloth
should help.


thanks for the suggestions. left it for two weeks as advised, but very
little change. then applied mayonnaise (hellermans) leaving it on thickly
for a day. but sad to say no real change. any other thoughts gratefully
received. thanks

  #8   Report Post  
jw 11111
 
Posts: n/a
Default


"GerryG" wrote in message
...
First, take a good look with a raking light. If the surface of the finish
looks porous, you would need to refinish that area. If not, see if you can
identify the finish. If it's very old, might even be shellac. Try warming
the
area with a hair dryer (note: warm, not-not hot), and try a cloth ball
with
just a little denatured alcohol, rubbing around the area and a firm
pressure.
Even if it's not shellac, the alcohol may help. Just keep the pad clean.
GerryG



tried the hairdryer no joy. tried the toothpaste and bingo! success.
many thanks to y'all. my life will now be spared, since this is the wife's
old but much loved dressingtable. thanks again. john west





Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
### micro-FAQ on wood # 024 P van Rijckevorsel Woodworking 0 November 13th 04 08:02 PM
### micro-FAQ on wood # 023 P van Rijckevorsel Woodworking 0 November 1st 04 08:35 AM
### micro-FAQ on wood # 020 P van Rijckevorsel Woodworking 0 September 24th 04 07:44 AM
### micro-FAQ on wood # 015 P van Rijckevorsel Woodworking 0 July 22nd 04 06:51 PM
### micro-FAQ on wood # 014 P van Rijckevorsel Woodworking 0 July 10th 04 01:38 PM


All times are GMT +1. The time now is 06:57 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"