Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Mitre Saw Laser Tip
Hi,
I have a cheap CMS with a laser. It is badly positioned (at the back) and when you cut wood, it shoots ALL the dust / chippings at the laser. This is incredibly hard to clean, because it's recessed a little. I have a solution! Give the laser a good clean, (toothbrush, cotton bud) and then apply a small piece of sellotape (see-thru sticky tape). This then gets rid of the recess, and is easier to clean. This in fact works like a filter on a camera for all of you who are photographers Sam |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Laser level??? Sorta........ | Metalworking | |||
Argon Laser, 150mW, American Laser | Electronics | |||
Compound Mitre or TS | Woodworking | |||
JDS Uniphase SLM uGreen 532 nm DPSS Laser problems | Electronics Repair |