On Jan 29, 9:18*am, Morris Dovey wrote:
Lowell Holmes wrote:
"-MIKE-" wrote in message
...
Robatoy wrote:
Make sure you use the square-corner bit.

Did this go over my head?

I think it might be a chisel. *:-)

I do have the Whiteside inlay kit. It has a small diameter bit, but not that
small.

Think V-bit - the square corner is cut by raising the bit so that the
point cuts the right angle. It (almost) requires CNC control.

Next up, I'd like to see that same inlay pattern with a slight undercut
to give the inlay material a better chance to hold.


The chemical aggressiveness, on a molecular level, creates a bond that
is almost pure.
We are talking cohesion as well as adhesion. IOW.. no need for
undercutting, smarty-pants. G