I have a Dewalt 682k Plate Joiner (biscuit joiner) and at times I would like to use size FF biscuits. Is there any way to adjust the Dewalt 682k so I can use them?

"silver_18038" wrote in message
...

I have a Dewalt 682k Plate Joiner (biscuit joiner) and at times I would
like to use size FF biscuits. Is there any way to adjust the Dewalt
682k so I can use them?

This is accomplished on the PC by putting on a much smaller blade AND
increasing the plunge by about 1 additional inch.

Can you make your DeWalt do that?

I really don't know if the DeWalt has an extra small blade.

"silver_18038" wrote in message
...

Leon;1932670 Wrote:
"silver_18038" wrote in message
...-

I have a Dewalt 682k Plate Joiner (biscuit joiner) and at times I
would
like to use size FF biscuits. Is there any way to adjust the Dewalt
682k so I can use them?-

This is accomplished on the PC by putting on a much smaller blade AND
increasing the plunge by about 1 additional inch.

Can you make your DeWalt do that?

I really don't know if the DeWalt has an extra small blade.


Well, I do not think that it does, more importantly IIRC the DeWalt cannot
be set to plunge and extra inch over the "20" setting to allow a small blade
to reach the wood. The working of the PC Plate Joiner are more articulate
than the DeWalt. The PC has normal plunge settings for the regular biscuit
sizes but when you remove the bottom plate and change to a smaller blade you
also adjust a lever that allows the tool to plunge about 1" farther than
normal.

"silver_18038" wrote in message

Can you make your DeWalt do that?

I really don't know if the DeWalt has an extra small blade.


They don't.