About Us

jenny

www.edlite.hk Only 11 mm slim light
box in China

WELCOME
Thank you for purchasing the Edlite Ultra Slim light box. Before
using, kindly please read the following instructions in order to avoid
any functional disorders or damages.

DESCRIPTION

Item Description
Model ED-F1 (Flip-open) series
Frame size ¡Á ¡Á mm
Visual size ¡Á mm
Film size ¡Á mm
Power W¡Á
Vol./Freq. 220V 50/60Hz

PRECAUTIONS
* Be sure that the power supply voltage of the area where this unit
will be used meets the required power supply.

MAINTENANCE AND CARE
1. Do not jolt the light box.
2. Do not handle the light box or power cord when your hands are wet
or damp.
3. For cleaning the heavier dirt, dampen a soft cloth in a weak
solution of mild detergent, wring it out dry, and wipe away the dirt.
Following this, dry immediately with a clean cloth.
4. Only change the tube if it has completely cooled down.
5. Place the light-box in a well-ventilated location to avoid
overheat.
6. Beware the cord should not be damaged from time to time.

INSTALLATION
1. Carefully unpack the slim light-box
2. Flip open the aluminium frames, and take off the front panel.
3. By using the screws to fix the slim light box on the wall.
4. Please make sure the slim light box is firmly fixed on the wall
before plug in the power cord.

INSTALL & CHANGE VISUAL
1. Make sure the electricity power is switch off.
2. Flip open the aluminium frames, and take off the front panel.
3. Fix the photo onto the light panel by using the double sided
adhesive strip. (INSTALL)
4. Take off the old photo and place the new one on it.(CHANGE)
5. Place the front panel back, and close the aluminium frames tightly.
6. Switch on the electricity power and check the slim light box
function properly.

CHANGE BALLAST & FLUORESCENT TUBE
1. Switch off the electricity supply.
2. Flip open the aluminium frames, and take off the front panel.
3. Open the aluminium lamp cover.
4. Take off the ballast or the fluorescent tube from the lamp holder.
5. Replace the new ballast or fluorescent tube.
6. Put back the front panel and close the aluminium frames tightly.
* We are highly recommended a professional and qualified electrical
technician to
operate the replacement of fluorescent tube.
* Please be caution during change the fluorescent tube. The model of
the new tube, voltage, and power must be matched the original one.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Only 11mm slim light box in China!	jenny	UK diy	0	April 6th 07 08:16 AM
Only 11mm slim light box in China!	jenny	Home Ownership	0	April 6th 07 08:15 AM
Only 11mm slim light box in China!	jenny	Home Repair	0	April 6th 07 08:14 AM
light delay component for old garage door operator	Jeff Wisnia	Electronics Repair	13	September 15th 05 01:45 AM
Mo light delay component for old garage door operator	Jeff Wisnia	Electronics Repair	1	September 6th 05 05:17 PM

Menu

About Us