Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.woodworking
|
|||
|
|||
Depth of a rabbit or dado
Is there any rule of thumb about how deep to cut a rabbit or dado? I
have typically cut them to half the thickness of the stock, but I'm wondering if this may be overkill. Does the strength of the joint increase with the depth of cut? Thanks, Richard |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
TS Dado Cut With Dado Adjusted To An Angle of 12 Degrees? | Woodworking | |||
Router bit speed & depth for 3/4" by 1/4" dado in MDF | Woodworking | |||
Rabbit dump | Home Repair | |||
supporting a new tile floor- plywood depth, backer board depth? | Home Repair | |||
Freud "Dial a Dado" Query, also 6" v 8" dado question... | Woodworking |