I don't recall the OP, but here's the solution you're after.
You probably have the gig completed by now, but here's a suggestion for
any future challenges.

http://tinyurl.com/peo89

After you use it, then finish with a regular small round-over router bit.

r

Robatoy wrote:
I don't recall the OP, but here's the solution you're after.
You probably have the gig completed by now, but here's a suggestion for
any future challenges.

There's also this one, which leaves a rounded edge.

http://www.leevalley.com/wood/page.a...09&cat=1,46168

Chris

In article ,
Chris Friesen wrote:

Robatoy wrote:
I don't recall the OP, but here's the solution you're after.
You probably have the gig completed by now, but here's a suggestion for
any future challenges.

There's also this one, which leaves a rounded edge.

http://www.leevalley.com/wood/page.a...09&cat=1,46168

Chris

*S*...yabbut... the challenge at hand was to continue the no-drip edge into the
inside corner of an L-shaped counter top...