 |
|
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#10
|
|||
|
|||
On Sun, 03 Jul 2005 21:36:09 GMT, The Critic
wrote: I have a NEW general international table saw, and I'm finding it exceeding difficult to change the blade. My arbor (not a General) has a large round collar with small round holes drilled into it radially. Although you could lot these with a straight rod as a tommy bar, it's very awkward (and chews up the holes). Much better was to forge a well-fitting C spanner, which locks more easily and doesn't wobble. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Table saw blade sharpening advice??? | Woodworking | |||
| FAQ: HAND TOOLS (Repost) | Woodworking | |||
| Craftsman new table saw owners - wheres your blade alignment | Woodworking | |||
| Dado blade on a Bosch bench table saw??? | Woodworking | |||
| Dry carbide blade in small table saw? | Metalworking | |||
Threaded Mode
