 |
|
| Woodturning (rec.crafts.woodturning) To discuss tools, techniques, styles, materials, shows and competitions, education and educational materials related to woodturning. All skill levels are welcome, from art turners to production turners, beginners to masters. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
DC Control Printed Board
Hi Group:
I bought a surplus GE motor with a PWM (Pulse Width Modulation) printed board. The board now causes the motor to vibrate and run rough, particularly noticable at low speed on my lathe. I've been able to prove the board is at fault, by trying a different board temporarily. Does any one have a spare board or know where to acquire one? Joe Yablonski -- Remove par from email address for replying |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Carrier Gas Furnace (forced Aire) blow only cold air | Home Repair | |||
| Kenmore Eliter dryer electronic control board repair | Electronics Repair | |||
| Mits CS-3535R PIP board pinouts - big pip board | Electronics Repair | |||
| Maytag Touchpad and Electronic Control Circuit Board Assembly | Home Repair | |||
| Z80 control board / EPROM Programming | Electronics | |||
Threaded Mode
