Home |
Search |
Today's Posts |
|
Woodturning (rec.crafts.woodturning) To discuss tools, techniques, styles, materials, shows and competitions, education and educational materials related to woodturning. All skill levels are welcome, from art turners to production turners, beginners to masters. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Lamp turning
Hello all,
This evening, I had the basically sound idea that I should turn a lamp... I went out and got the hardware and decided that the plank of bird's eye maple I had down in the shop would look great as a lamp base. So, I got the blank cut to size and ready for assembly (I'm using all kiln-dried lumber for now, so most or all of my blanks are laminated) I figured that it'd be a whole lot easier to run the wires through the finished lamp if I left a space in the center, so I cut a half inch out of the middle of the center plank, and made some nice plugs for each end to set the centers into. Seemed like a good idea at the time, but it turns out that the hole in the center really should be square, and not .75 x .5! So, I got it up on the lathe, and started turning away. Everything was basically fine except for a bit of extra vibration, until I turned off the lathe to check my progress. Turns out that bit of extra vibration caused the panels to crack apart about 1/32 of an inch in four spots right in the most prominant space on the lamp. The cracks are about 4" long, and approximately 1/16" deep. I tried sanding the sucker for alomst an hour with 60 grit to no avail, and any attempts to cut or scrape the area just makes the gaps wider and deeper. And as an extra kick in the pants, most of the bird's eyes turned right out of the blank- so it just looks like regular maple with a little curl to it. I doubt I'm going to save this piece unless I just fill it with wood putty and paint it, but I was wondering if any of you folks have had similar problems, and what my best options for avoiding this in the future may be... Thanks! Aut inveniam viam aut faciam |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Samsung HLN4365W HDTV Lamp Dies | Electronics Repair | |||
Pen Turning Initial Shopping List | Woodturning | |||
Pen Turning Initial Shopping List | Woodturning | |||
Kelton Balancer Review Draft--long | Woodturning |