hi guys hope someone can help me with this, when using the cembre hp ratchet crimper which way round should the crimp go into the tool, i ask this because i have seen people use these in different ways.

On 15/08/2020 10:46, michael m wrote:

hi guys hope someone can help me with this, when using the cembre hp
ratchet crimper which way round should the crimp go into the tool, i
ask this because i have seen people use these in different ways.

Is this a "normal" crimp tool for insulated crimps? If so, then the
crimp goes in such that the metal part of the crimp is the bit that gets
crimped, not the unfilled plastic shroud. See:

http://wiki.diyfaq.org.uk/index.php/...crimping#Crimp


--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/