Home |
Search |
Today's Posts |
|
UK diy (uk.d-i-y) For the discussion of all topics related to diy (do-it-yourself) in the UK. All levels of experience and proficency are welcome to join in to ask questions or offer solutions. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to uk.d-i-y
|
|||
|
|||
Honda GX200 exhaust question.
Hi All,
I've just picked up a second hand GX200 powered 3KVA genny and there is what looks like a fine mesh disk rattling about in the actual exhaust outlet. It would fall out but it's otherwise trapped by the other heat shield. I think the PO suggested there may have been an additional outer deflector on the exhaust box and I'm wondering if that also had something to do with holding whatever_this_is in place? Does anyone have such an engine and know how that area is supposed to go together please? If there are some bits missing, would you know if they are available separately, if not, would one of the aftermarket exhausts on eBay be ok (ok = no noisier and give full power etc). On that and if I am going to get a new exhaust anyway, I have here a fairly new exhaust off a 125cc 4/ scooter [1] that, with a bit of tweaking and in the spirit of d-i-y etc could be made to fit within the general genny frame (it's an open cage type). Would you think this might be quieter than the stock exhaust, if bigger is better it should be and as I already have it etc? Cheers, T i m [1] I think the (125cc) scooter did about 8K rpm and this (200cc) Honda does about 4k rpm so I don't think the exhaust would be two restrictive. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Honda Generaor Maintenance question? | Home Repair | |||
Honda EU200i Generator Question | Home Repair | |||
Honda powered pressure washer question | Metalworking | |||
Question: 3/4" Honda shaft key way retention ? | Metalworking | |||
Need Help with Dell GX200 MB problem... | Electronics Repair |