Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Question: 3/4" Honda shaft key way retention ?
I have a Honda motor, with 3/4" male shaft with a keyway cut the full
length. This shaft mates to a 'Direct drive' pressure washer pump. Just had the pump repaired and when re mounting the motor, I am not sure what keeps the 'key' from moving in and out on the keyway and falling out. -- NosMo **************************** |
#2
Posted to rec.crafts.metalworking
|
|||
|
|||
Question: 3/4" Honda shaft key way retention ?
sometime set screw, sometimes the pump will have no way for it to get
out on the pump side. |
#3
Posted to rec.crafts.metalworking
|
|||
|
|||
Question: 3/4" Honda shaft key way retention ?
Thanks Doug. On further inspection, you are right. It can not slide out. My brain fart. david "Doug" wrote in message oups.com... sometime set screw, sometimes the pump will have no way for it to get out on the pump side. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
OT Brigs & Stratton Horizontal Shaft Question. | Metalworking | |||
OT Guns more Guns | Metalworking | |||
this ought to get everybody fired up.... | Woodworking |